Zanussi ZWD 12270 S1 - Manual (Page 25)

25
Malfunction Possible Cause / Solution
The washer-dryer does not start:
The door has not been closed. E40
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse or the fuse in the plug has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
button
has not been pressed.
• Please turn the selector dial and press the button
again.
The «Child Safety Lock» option has been selected.
• Disable the «Child Safety Lock» option.
6
6
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked. E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked. E10
• Clean the water inlet hose filter.
The door is not properly closed. E40
• Close the door firmly.
What to do if...
IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red pilot light of the button
flashes, the buzzer
sounds and one of the following alarm codes appears on the display to indicate that the machine
is not working.
●
E10 : problem with the water supply
●
E20 : problem with water draining
●
E40 : door open.
Once the problem has been eliminated, press the button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
6
6