Xerox 8290 - Manual (Page 32)

3 Printer Setup
24 8265/8290/8365/8390 User Guide
Notes
When raising or lowering the pressurize rollers, you can use the foot switch instead of the operation panel.
Step 5 :
Open the front cover.
Caution
Be careful not to pinch your fingers when opening and closing the front cover.
Step 6 :
Load the sheet media into the insertion slot at the front of the printer.
1 Sheet media
2 Insertion slot
Step 7 :
Set the right edge of the media so that it is parallel with the media setting position.
Notes
• The media set position is a guideline for setting up the media.
• If the right edge of the sheet media is 5 mm or more from the media setting position, a media set error
may occur if the media is not detected. Make sure to set the right edge of the sheet media within 5
mm of the media setting position.
1 Sheet media
2 Media loading position
Step 8 :
Press the [F4] key on the operation panel to lower the pressure rollers.