Yeoman CL MILNER BRICK YMMB - Manual (Page 20)

20
INSTALLATION INSTRUCTIONS
2. REMOVAL OF THE DOOR
2.1 To remove the door:
—
Using a 5mm A/F Hey Key remove the door by opening,
removing the 4 bolts and lifting the door free of the
appliance body.
PR7084 4 Bolts
3. REMOVAL OF THE LOG GUARD
3.1 To remove the log guard:
—
Lift log guard clear of the supporting brackets.
—
Rotate to clear the sides of the door opening.
Do not use appliance without the log guard in position.
4. REMOVAL OF THE BAFFLE
4.1 The appliance is fitted with a baffle in the top of the firebox
to maintain efficient combustion.
4.2 Allow the appliance to cool fully before removing baffle
system.
PR9040
Baffle
5
4.3 Remove the log guard from the appliance to give access to
the firebox.
1.5 Reposition clamps by hand through the flue opening and
tighten using a 13A/F spanner. Check the clamps are
against the throat forming lintel as shown in Diagram 3.
PR9039
3
Reach through door
and up and out
of flue opening to
adjust clamps
Throat
forming lintel
Clamp
Milner
brick
ø 16mm
Rope seal
1.6 Check the ø16mm rope seal is still in the correct position.
The appliance must be sealed against the face of the
chimney breast / fire surround and at the hearth to the base
of the appliance. This seal must be made air-tight with the
use of heat resistant sealant such as fire cement or very
high temperature flexible sealer.
1.7 Drill 2 appropriately placed ø10mm holes in the Milner
hearth. Secure the stove to the hearth via the holes shown
in Diagram 4 using metal wall plugs and bolts.
PR9034
4
Attach stove to
hearth via holes
in floor of stove
1.8 Refit all internal components.