Yamaha DPX-1200 - Manual (Page 18)

14
1. Press the STANDBY/ON button.
A confirmation message appears on the
screen.
◆ Placing the DPX-1200 in standby mode
2. If you wish to place the DPX-1200
in standby mode, press the
STANDBY/ON button again.
The lamp changes to a half lit state, and the
fan activates for 2 minutes to cool the lamp.
During this time, the STANDBY/ON
indicator blinks orange, and pressing
STANDBY/ON does not turn main unit
power on again. When the unit finishes
cooling, the fan stops, and the STANDBY/
ON indicator turns orange.
Memo
• The lamp may blink when half lit. This is not a defect.
Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green
or when the fan is activated. This could damage the lamp or reduce lamp life.
• If you do not plan to use the main unit for a long period of time, attach the lens cap
and remove the plug from the AC outlet.
• Condensation may appear on the unit if the temperature of the surrounding
environment changes quickly. Condensation may also cause the projected image to
be cloudy. Place the unit in standby mode until the condensation disappears.
Switching the unit on when condensation is present may damage the unit.
Turning the projector power on
AC inlet
Press again to enter standby.
HDMI
G/Y B/PB/CB R/PR/CR
INPUT A
HD/SYNC VD
OUT IN REMOTE TRIGGER OUT
S-VIDEO VIDEO
INPUT B
RGB/YPBPR/YCBCR
RS-232C
D4 VIDEO
INPUT
MENU
PATT IRIS
AUTO
SETTING
ASPECT
ZOOM FOCUS V. POS
ESCAPE
STANDBY/ON
SETTING
LAMP COVER TEMP FAN
PATTERN
ESCAPE MENU
INPUT ASPECT
Remote Control Main unit
button STANDBY/ON button
12_DPX-1100_E.p65 11/26/04, 1:47 PM 14