Zanussi ZU 7115 - Manual (Page 16)

Hook the decorative panel onto the top part of the
door, inserting the pins (B) (on the door) into the
elongated holes (1) (in the top bracket fitted to the
panel).
Insert the securing screws (C) through elongated
holes (2) and fix the panel without tightening the
screws.
Once the top of the panel has been correctly
positioned, fix it through the holes in the bottom
bracket, without tightening the screws.
Check the position again by slackening the screws
and pins then, once the best position has been
obtained, fully tighten all the fixings. Cover the visible
part of the top bracket on the panel with plastic cover
(D), inserting it in the locations provided in the bracket.
Once the door has ben correctly aligned, tighten the
holding nuts on the fixing brackets and attach the
appliance to the adjacent units and the bottom of the
work surface.
For a correct installation operation if the base plate is
more than 100 mm (for cavity height 820 mm) or more
than 150 mm (for cavity height 870 mm) you must cut
out the plate as shown in the diagram.
16
D533
1
B
2
C
D471
D472
D
D517
450
D593