ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 143)

HomeSafe User’s Guide
NAT Screens 10-1
Chapter 10
Static Route Screens
This chapter shows you how to configure static routes for your HomeSafe.
10.1 Static Route Overview
Each remote node specifies only the network to which the gateway is directly connected, and the
HomeSafe has no knowledge of the networks beyond. For instance, the HomeSafe knows about
network N2 in the following figure through remote node router R1. However, the HomeSafe is
unable to route a packet to network N3 because it doesn't know that there is a route through the
same remote node router R1 (via gateway router R2). The static routes are for you to tell the
HomeSafe about the networks beyond the remote nodes.
Figure 10-1 Example of Static Routing Topology
10.2 Configuring IP Static Route
Click STATIC ROUTE to open the screen as shown next.
Figure 10-2 Static Route
The following table describes the labels in this screen.