Zenith Z56DC1D - Manual (Page 16)

16 DLP Projection TV
The TV has a special signal output capability which allows you to
hook up a second TV or monitor.
Connect the second TV or monitor to the TV’s AV OUT. See the
Operating Manual of the second TV or monitor for further details
regarding that device’s input settings.
Note
• Component, RGB-PC/RGB-DTV, HDMI/DVI, DTV input sources
cannot be used for AV out.
A A V Out Setup V Out Setup
(L)
(R)
S-VIDEO
(L)
(R)
AUDIO
VIDEO
AV IN 1 AV OUT
DIGITAL AUDIO
OPTICAL OUT
HDMI
/DVI IN
S-VIDEO IN
(R) AUDIO (L) VIDEO
MONO
How to connect
Use the TV’s COMPONENT (Y, PB, PR) INPUT, RGB, HDMI/DVI jack for
video connections, depending on your set-top box connector. Then, make
the corresponding audio connections.
Note: HDMI(High Definition Multimedia Interface): Input that accepts uncom-
pressed digital signal and multi channel digital audio signal.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the digital
set-top box.)
2. Use INPUT on the Remote Control to select Component 1, Component
2, RGB-DTV or HDMI/DVI source.
HDSTB Setup HDSTB Setup
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
Signal
480i
480p
720p
1080i Component 1/2
Yes
Yes
Yes
Yes
RGB-DTV,HDMI/DVI
No
Yes
Yes
Yes