Zenith Z56DC1D - Manual (Page 45)

Owner’s Manual 45
Programming the Remote Programming the Remote
1. Test your Remote Control.
To find out whether your remote control can operate the device
with out programming, turn on the device such as a the VCR
and press the corresponding mode button (VCR) on the remote
control while pointing at the device. Test the POWER and
CH +/- buttons to see if the device responds properly. If not, the
remote requires programming to operate the device.
2. Turn on the device to be programmed. Then press the cor
responding mode button on the Remote Control.
3. Press the POWER button and the MUTE button simulta
neously. Now the Remote Control is ready to program the
code for the corresponding device.
4. There are two ways to find the right code for the device.
A. If you press the CH +/- buttons repeatedly, the codes will
change one at a time. Press the POWER button after each
code change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the Remote
Control. The right code numbers for the corresponding compo-
nent can be found on the following pages.
Again, if the code is correct, the device will turn off.
5. Press the EXIT button to store the program.
6. Test the Remote Control functions to see if the device
responds properly. If not, repeat from step 2.
1 2 3
4 5 6
7 8 9
0
TV
MODE LIGHT POWER
INPUT INFO
HDMI/DVI
VCR CABLE DVD SAT
MUTE
EZ PIC SRS APM EZ SOUND
RATIO
MENU EXIT
CC FREEZE GUIDE
VOL CH
FAV
SAP ADJUST
TIMER RGB-PC
TV INPUT
FLASHBK
+
-
ENTER
2
4
5
3
4
The Remote Control for your HD receiver is a multi-brand or universal Remote Control that can
be programmed to operate most remote-controllable devices of other manufacturers.
Note: The Remote Control may not be able to control all models of other brands.
3