Yamaha RX-V3900 - Manual (Page 100)

96
En
Graphical user interface (GUI) menu
DNS Server (P) (Primary DNS server)
DNS Server (S) (Secondary DNS server)
Use this parameter to specify the IP address of the primary
and secondary DNS (Domain Name System) servers.
If you have only one DNS address, enter the DNS address in
“DNS Server (P)”. If you have two or more DNS addresses,
enter one of them in “DNS Server (P)” and another in “DNS
Server (S)”.
■ Network Standby (Network standby)
Use this feature to select whether this unit accepts the
commands via LAN network when this unit is in the
standby mode.
When “Network Standby” is set to “On”, the amount of power
consumption in the standby mode increases.
■ Information (Network information)
Use this feature to display the network system
information.
MAC Address
(MAC (Media Access Control) address)
This information displays the MAC address that is
assigned to this unit.
Status (Network status)
This information displays the current link status of the
network.
Display status: 10BASE-T, 100BASE-TX, No Link,
Full Duplex, Half Duplex
“No Link” appears when network connection is not made.
System (System ID)
This information displays the system ID that is assigned to
this unit.
Use this menu to set the functions of the multi-zone
configuration.
■ Zone SP Assign
(Zone speaker assignment)
Use this feature to assign the speaker terminals for Zone 2
and Zone 3.
1
Press 9k / n to select the speaker terminal
and then press 9l / h repeatedly to select
the desired zone of which you want to use
the speakers.
M : Main zone
2 : Zone 2
3 : Zone 3
2
Press 9k / n to select “OK” and then press
9
ENTER to confirm the setting.
y
To return to the previous menu level without change,
select “CANCEL” in step 2.
■ Zone2 Set/Zone3 Set
(Zone 2/Zone 3 settings)
Zone2 Volume/Zone3 Volume
(Zone 2/Zone 3 volume)
Use this menu to select whether this unit controls the
volume level of the audio signals output at the ZONE
OUT (ZONE 2 or ZONE 3) jacks.
Note
Choice Descriptions
Off Does not accept the operations via LAN
network when this unit is in the standby mode.
On Accepts the operations via LAN network when
this unit is in the standby mode.
Note
Note
Setup (Multi Zone)
Choice Descriptions
Fixed Select this setting when you want to control the
volume level of the selected zone on the external
amplifier. This unit fixes the ZONE OUT
(ZONE 2 or ZONE 3) volume level to a standard
line level.
Variable Select this setting when you want to control the
volume level of the selected zone on this unit.
You can adjust the ZONE OUT (ZONE 2 or
ZONE 3) vo
lume level simultaneously with
JVOLUME +/– on the remote control.
Zone SP Assign
Zone2 Set
Zone3 Set
SP1
SP2
M 2 3
Zone :
SP Terminal :
– 2 3
CANCEL OK