Yamaha RX-V3900 - Manual (Page 37)

33
En
Optimizing the speaker setting for your listening room
PRE
P
ARA
T
ION
English
Use this feature to optimize the setup of this unit for
multiple listening positions. You can also select the
parameters to be optimized by the automatic setup.
1
Turn on the video monitor and then connect
the optimizer microphone to the OPTIMIZER
MIC jack on the front panel.
2
Place the optimizer microphone at the first
listening position.
The following illustration shows how to place the
optimizer microphone in order to optimize the setup
of this unit for seven listening positions for example.
1/2/3/4/5/6/7: Listening positions
3
Press I
MENU on the remote control.
The GUI menu appears in the video monitor.
4
Press 9k to select “Setup Menu” and then
press 9h.
5
Press 9k / n repeatedly to select “Multi
Measure” and then press 9h.
6
Press 9k / n repeatedly to set the number of
listening positions and press 9l.
Choices: 1 (default), 2, 3, 4, 5, 6, 7, 8
7
To select the parameters to be optimized,
press 9k / n to select the parameter and
then press 9
ENTER to check or uncheck
the box.
When you do not need to select the parameters to be
optimized, skip to step 8.
y
If you do not select the parameters to be optimized, this
unit will optimize the parameters you selected last time.
All the parameters are selected by the initial factory
settings.
8
Press 9l to return to the previous menu
level and then press 9n to select “Start”.
9
Press 9
ENTER to start the measurement.
This unit starts to count down from 10 seconds.
y
• To start the measurement immediately, press 9ENTER
again.
• To cancel the automatic setup and return to the previous
screen, press 0RETURN.
Loud test tones are output from each speaker during
the measurement. Once all items for the first listening
position are measured, the following message
appears.
Advanced automatic setup
1 7
2 6
4 3 5
Information
Setup Menu
Start
Multi Measure 1
Wiring
Distance
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. During the
automatic setup procedure, do not perform any operation on
this unit. For more accurate measurements, we recommended
that you get out of the room or move to the wall where
speakers are not around during the measurement.
Information
Setup Menu
Start
Multi Measure 7
Wiring
Distance
[ ]
Pre Check
Main Check
Wiring
Distance
Put the microphone at
2nd listening position
Next:ENTER
Skip: