ZyXEL Communications VES-1000 - Manual (Page 28)

VES-1000 Series Ethernet Switch
2-2 Hardware Connections
To connect the VES-1012 only, plug the female end of the power cord to the power receptacle on the rear panel.
Connect the other end of the cord to a power outlet. Make sure that no objects obstruct the airflow of the fans
(located on the side of the unit).
2.3 Front Panel
The following figure shows the front panel of the VES-1012 only. The VES-1008 has a combined USER/CO
Telco-50 connector and displays 8 VDSL ports instead of the 12 that are on the VES-1012. The VES-1008 also
has the socket and switch for the power supply located on the front panel.
Figure 2-2 VES-1008 Front Panel
Figure 2-3 VES-1012 Front Panel
2.4 Front Panel Ports
Table 2-A VES-1000 Series Switches: Front Panel Ports
VES-1008 FRONT PANEL PORTS
CONNECTOR DESCRIPTION
CONSOLE The CONSOLE port is an RS-232 port for local configuration of the VES-1000 Series
switch.
USER/CO The combined USER/CO port is a Telco-50 connector for external POTS/ISDN and VDSL
connections.
Two 10/100 Mbps
RJ-45 connectors These ports connect to a Ethernet switch or WAN router.
VES-1012 FRONT PANEL PORTS
CONNECTOR DESCRIPTION
CONSOLE The CONSOLE port is an RS-232 port for local configuration of the VES-1000 Series
switch.
CO The CO Telco-50 port connects to the central office or a PBX.
USER The USER Telco-50 port connects to the user (subscriber) VDSL equipment.
Two 10/100 Mbps
RJ 45
t
These ports connects to a Ethernet switch or WAN router.