ZyXEL Communications VES-1000 - Manual (Page 40)

VES-1000 Series Ethernet Switch
4-2 General, Switch and IP Setup
Figure 4-2 Menu 2 - Switch Setup
Table 4-B Menu 2 – Switch Setup
FIELD DESCRIPTION EXAMPLE
VDSL Mode Press [SPACE BAR] and then press [ENTER] to choose from
10BaseS, ETSI Plan 997 or ANSI/ETSI Plan 998. 10BaseS
VDSL Modem Firmware
Auto Upgrade Press [SPACE BAR], select Yes, and then press [ENTER] to allow
automatic firmware upgrade of the subscribers VDSL modem. Yes
Ethernet Port 13 and Port
14 Trunking Ethernet port trunking is disabled by default. Press [SPACE BAR],
select Yes, and then press [ENTER] to allow trunking (make sure the
remote switch also supports trunking).
Enable trunking (press [SPACE BAR], select Yes) only if you connect
both Ethernet ports to a single switch. (Ethernet ports 13 & 14 relate
to the VES-1012 switch only).
No
Edit Spanning Tree
Protocol Press [SPACE BAR] once to select Yes and then [ENTER] to display
Menu 2.1 - Spanning Tree Protocol Setup. No
Edit GARP Timer Press [SPACE BAR] once to select Yes and then press [ENTER] to
go to Menu 2.2 — GARP Timer Setup. No
VLAN Type Press [SPACE BAR] and then press [ENTER] to choose from 802.1Q
or Port-Based. See section 4.2.8 for more information on VLANs. To
enable IEEE 802.1Q on the VES-1000 Series switch, you must
configure it for the switch in this menu, menu 6 port submenu(s) and
menu 17 VLAN setup. Menu 17 is not applicable (N/A) if you choose
port-based VLANs for the switch in menu 2. 802.1Q
IGMP Snooping Press [SPACE BAR] once to select Enable and then press [ENTER].
Press [ENTER] again at the message “Press ENTER to Confirm…“ to
activate IGMP snooping on the device. Disable
Edit QoS Support Press [SPACE BAR] once to select Yes and then press [ENTER to
go to Menu 2.3 — QoS Setup. No
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your
configuration, or press [ESC] at any time to cancel.
Menu 2 - Switch Setup
VDSL Mode= 10BaseS
VDSL Modem Firmware Auto Upgrade= Yes
Ethernet Port 13 and Port 14 Trunking= No
Edit Spanning Tree Protocol= No
Edit GARP Timer= No
VLAN Type= 802.1Q
IGMP Snooping= Disable
Edit QoS Support= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.