XM Satellite Radio R-672 - Manual (Page 16)

ENGLISH
16
When CD, AUX, VIDEO 1~2 is selected as an
input source
• "MUTE" will flicker.
• To resume the previous sound level, press it again.
• Each time this button is pressed, the corresponding
input is selected as follows:
A(nalog) o(ptical) 1 o(ptical) 2
c(oaxial) 2 c(oaxial) 1
Notes :
• When TUNER, TAPE, EXTERNAL IN or VIDEO 3 is
selected as an input source, the analog input is selected
automatically.
• When the selected digital input is not connected, the
"DIGITAL" indicator flickers and the analog input is
automatically selected.
• The selected digital or analog input is automatically
assigned to the corresponding input source on the
INPUT setup menu. (For details, refer to "SETTING
THE INPUT" on page 39.)
• The sound from the component connected to the
selected digital input can be heard regardless of the
selected input source.
4.
Select the digital or analog input connected as desired.
5.
Operate the selected component for playback.
6.
Adjust the (overall) volume.
7.
To mute the sound.
• Ensure that the SPEAKER button is set to off.
• Depending on the signal format which is being input, you
can listen in different Dolby Headphone modes, stereo
mode, etc. (For details, refer to "Listening in a Dolby
Headphone mode" on page 21).
• When the EXTERNAL IN is selected as an input source,
only front left and front right channel signals can be
reproduced through the headphones.
8.
To listen with the headphones.
• When playing back the program sources with surround
sound, refer to "ENJOYING SURROUND SOUND" on
page 20.