Yamaha SU700 - Manual (Page 30)

30 Chapter 1 SU700 Components, Connections, and Startup
Chapter 1
SU700 C
omponents, C
onnections, and S
tar
tup
To enable input, you must set the AUDIO IN parameter to the source you wish to
use. You can set the parameter using the SYSTEM | SETUP job; see page 302. The
SU700 can only accept input from one source at a time.
R L/MONO
STEREO OUT
R L
ANALOG INPUT
Output
You can connect any or all of the following.
●
Connect amplifiers, powered speakers, mixer, analog recorder, or other such device
to the STEREO OUT jacks on the rear panel.
IMPORTANT
If you are connecting up a single speaker or amp only, be sure to connect to the L/MONO
jack.
NOTE:
If connecting to a device with adjustable pan (such as a mixer) set the pan for the channel
receiving the L/MONO output all the way to the left; set the pan for the RIGHT output all
the way to the right.
●
Connect headphones to the PHONES jack on the front panel.
●
(If you have installed the optional AIEB1 board:) Connect speakers to any of the
ASSIGNABLE OUT jacks on the rear panel, or connect a digital device to the DIGI-
TAL OUT or OPTICAL OUT connector on the rear panel.
If using powered speakers, connect as shown below.
CD Record (turntable) Microphone
Electric keyboard