Zoom FIRE-36 - Manual (Page 11)

Using the FIRE-36
11 ZOOM FIRE-36
Using effects
The FIRE-36 incorporates two types of effects (modulation and delay/reverb). This section
explains how to activate the effects and use them to achieve various kinds of sound.
1.
To use a modulation effect, press the corresponding [TYPE] key.
The respective LED lights up and the modulation effect is activated. The selected effect type and
setting value are shown for about 2 seconds on the display.
Available modulation effect types and their abbreviations are listed in the table below.
2.
Use the [VALUE] knob.
For example, if you press the [CHORUS] key in step 1 and then operate the [VALUE] knob, the
setting value changes in the range from C1 to C9, with the effect intensity (in this example the
chorus modulation rate) changing accordingly.
(For details regarding effect types and setting values, see pages 19 - 22.)
H INT
• You can use only one type of modulation effect at a time.
• Also if the effect type and setting value are not currently shown on the display, the setting value of the
currently selected effect type (whose TYPE key LED is lit) will change.
3. To use a delay/reverb effect, turn the [TYPE/TIME] knob and select the effect type and
setting value you want to use.
Key (effect type) Code Key (effect type) Code
[CHORUS] key [AUTO WAH] key
[FLANGER] key [STEP] key
[PHASE] key [SLOW-A] (slow attack) key
[DOUBLING] key [PITCH] (pitch shift) key
[TREMOLO] key [RING MOD] (ring modulator) key
Setting value Effect type C 1
C W
F S
H A
D P
T R
FIRE36E.fm 11 ページ ２００４年６月２５日 金曜日 午前１１時１２分