Zoom FIRE-36 - Manual (Page 25)

3 ZOOM FIRE-36M
Thank you for selecting the ZOOM FIRE-36M. This product is a modified version of the Modeling Guitar
Amplifier FIRE-36M. It incorporates all the functions of the FIRE-36 and adds built-in mics for picking up the
sound of the speaker, and a set of direct output jacks. This document explains functions and specifications that
have been added or changed. For information on common functions and specifications, refer to the supplied
manual of the FIRE-36.
■ FIRE-36M features
In addition to providing equivalent functionality as the FIRE-36, the FIRE-36M offers the following features.
• It incorporates all the functions of the FIRE-36 and adds two built-in mics with dedicated
preamplifier for picking up the sound of the speaker. Without the need for cumbersome setup, you
can easily obtain dynamic mic sound (mic 1) and condenser mic sound (mic 2) of the guitar amp.
• RECORDING OUT connectors let you supply the amp signal directly to other equipment. Use the
mic input signals and the line output signal separately, or control the mixing balance between the
three signals for sending to a recorder or other external device.
■ Changes in controls and jacks
The following controls and jacks of the FIRE-36M are different from the FIRE-36.
Front panel
(1) [PHONES] jack
A pair of headphones can be connected to this jack. When a plug is inserted here,
the sound from the speaker is automatically cut off.
* The FIRE-36 manual states that this jack "can be used to connect a recording device or
a pair of headphones", but in the FIRE-36M, the jack is a dedicated headphone jack.
Rear panel
(1) RECORDING OUT [BALANCE] jack
This is a balanced XLR output jack which can be used to supply a
signal to the balanced input of a recorder or mixer.
(2) RECORDING OUT [UNBALANCE/PHONES] jack
This is an unbalanced TRS phone output jack which can be used to
supply a signal to the unbalanced input of a recorder or mixer. It can
also be used as an additional headphone jack. (The speaker is not cut
off when a plug is inserted here.)
(3) [LINE LEVEL] knob
This control adjusts the line signal level at the RECORDING OUT jacks (1) and (2).
If the knob is turned fully counterclockwise, no line signal is output.
(4) [MIC 1 LEVEL] knob
(5) [MIC 2 LEVEL] knob
These controls adjust the signal level for the dynamic mic sound (mic 1) and condenser mic sound (mic 2).
If the knobs are turned fully counterclockwise, no mic signal is output.
■ Using the signal from the internal mics
The FIRE-36M has two microphones and a dedicated preamplifier built into the cabinet to allow direct pickup
of the sound from the loudspeaker. The sound from the mics is mixed with the internal line signal of the
amplifier and supplied directly to the RECORDING OUT jacks.
This section explains how to supply the mic signals to an external recorder or other device via the RECORDING
OUT jacks.
(1)
(1) (2) (3) (4) (5)
ZOOM FIRE-36M Supplemental Manual
English
ZOOM FIRE-36M Supplemental Manual
Fire36m.fm 3 ページ ２００４年７月７日 水曜日 午前１０時３９分