Zoom FIRE-36 - Manual (Page 12)

Using the FIRE-36
12 ZOOM FIRE-36
When you operate the [TYPE/TIME] knob, the display shows the currently selected effect type
and the setting value.
The available delay/reverb effect types and the corresponding codes are shown in the table below.
When the knob is turned clockwise from the extreme left position, the effect type and value
settings cycle as follows: d1 - d9 (delay → E1 - E9 (echo) → r1 - r9 (room) → H1 - H9 (hall). (For
details regarding effect types and setting values, see page 22.)
4. Use the [MIX] knob to adjust the ratio of original sound (guitar sound) and delay/reverb
sound.
The setting range is 0 - 9. Turning the knob clockwise increases the depth of the delay/reverb
effect. Turning the knob fully counterclockwise turns the delay/reverb effect off.
H INT
You can change the effect settings of patches in the same way in program mode.
Loading and storing patches
The FIRE-36 offers a bank of ten read/write user patches (U) and a bank of ten read-only preset
patches (A, b). Patches in each bank are numbered 0 - 9.
This section explains how to call up stored user patches or preset patches and how to save
amplifier and effect settings in a user patch.
◆
Loading a patch
1. Press the [PROGRAM/BANK] key in the patch section, so that the LED lights up.
The FIRE-36 switches from manual mode to program mode, and the currently selected patch is
Key (effect type) Code Key (effect type) Code
DELAY ROOM
ECHO HALL
D 1 Setting value Effect type
D R
E H
FIRE36E.fm 12 ページ ２００４年６月２５日 金曜日 午前１１時１２分