4 configure vlan port settings – ZyXEL Communications XGS-4728F User Manual
Page 102
Chapter 9 VLAN
XGS-4728F User’s Guide
102
9.5.4 Configure VLAN Port Settings
Use the VLAN Port Setting screen to configure the static VLAN (IEEE 802.1Q)
settings on a port. See
for more information on static
VLAN. Click the VLAN Port Setting link in the VLAN Status screen.
Figure 49 Advanced Application > VLAN > VLAN Port Setting
Control
Select Normal for the port to dynamically join this VLAN group using
GVRP. This is the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN
group.
Tagging
Select TX Tagging if you want the port to tag all outgoing frames
transmitted with this VLAN Group ID.
Add
Click Add to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Clear
Click Clear to start configuring the screen again.
VID
This field displays the ID number of the VLAN group. Click the number to
edit the VLAN settings.
Active
This field indicates whether the VLAN settings are enabled (Yes) or
disabled (No).
Name
This field displays the descriptive name for this VLAN group.
Delete
Click Delete to remove the selected entry from the summary table.
Cancel
Click Cancel to clear the Delete check boxes.
Table 19 Advanced Application > VLAN > Static VLAN (continued)
LABEL
DESCRIPTION