Xantrex Technology ENERGY HW 1000 - Manual (Page 59)

Warning Messages
975-0467-01-01 5–7
For error codes E01 to E04:
• the unit will stop inverting, and
• the display screen and the alarm will turn off after 30 seconds.
For error codes E10 and E11:
• the unit will stop charging, but
• the error code will still show on the display screen and the alarm will
remain on, and
• AC power will continue to pass through to the AC outlets.
For error code E12
• the unit will stop charging and shut down, and
• the error code will show on the display screen briefly, and
• AC power will not pass through to the AC outlets.
To reset error codes E10 to E12:
1. Remove the AC input, and
2. Turn the unit OFF and then turn ON again using the Power button on
the display panel.