Zanussi FR 1450 W - Manual (Page 6)

1 ON/OFF button
Press this button to switch the washing machine on.
Press the ON/OFF button again to switch the machine
off.
2 MAINS-ON light
This light is connected to the ON/OFF button. It lights
up when you press the button, and goes out when you
press it again.
3 FABRICS button
Press this button repeatedly to select the programme on
the basis of the type of laundry to be washed. The light
relevant to the selected programme will light up. The
washing machine will propose a temperature and
automatically select the maximum spin value provided
for the programme you have chosen. You can change
these values by operating buttons 4 and 5.
4 TEMPERATURE button
Press this button repeatedly to increase or decrease the
temperature, if you want your laundry to be washed at a
temperature different from the one proposed by the
washing machine. The relevant light will light up.
Maximum temperatures are 95°C for cotton, 60°C for
synthetic fabrics, 40°C for delicate fabrics and wool.
6
The Control Panel
SPIN SPEED
PREWASH 1200
900
700
500
RINSE
HOLD
START/PAUSE RESET
FABRICS
TEM
PERATU
RE
SYNTHETICS
DELICATES
COTTONS
60°C
50°C
95°C
40°C
30º C
FR 1250 W
ON/OFF WOOL
40 AA
OPTIONS
SKIP HALF
LOAD
1 3 2 4 5 6 9 8 7
5 SPIN SPEED button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed different
from the one proposed by the washing machine. The
relevant light will light up.
Maximum speeds are:
• for cotton: 1400 rpm (FR 1450W)
1200 rpm (FR 1250W-FR 1250S));
• for synthetic fabrics and wool 900 rpm;
• for delicate fabrics:700 rpm.
RINSE HOLD position when you choose this option,
the machine will not drain the water of the last rinse, so
as not to crease the laundry.
At the end of the cycle, the light of the START/PAUSE
button goes out, the
and lights go on, the
DOOR LOCKED light remains lit, to indicate that the
water must be drained.
To complete the cycle, first press SKIP/RESET button
and then choose one of the following options:
• Drain only
:
- Press FABRICS button in order to select the desired
programme and press 3 times SKIP/RESET button
until the light
goes on. Then depress
START/PAUSE button.
IMPORTANT!
By pressing the TEMPERATURE and SPIN SPEED
buttons simultaneously, the acoustic signal is
deactivated at the end of the cycle, when selecting
the programmes and in case of an incorrect option
selection .
By pressing these 2 buttons again the acoustic signal
is reactivated.