Yamaha Magicstomp BASS EFFECTS PROCESSOR - Manual (Page 20)

20
_ U01¤Studio
NAME EDIT MODE U01:Studio
PRESS[STORE]1sec
Press and hold
P01⁄Studio
ó‡CRATfiGAINáMSTR U01:Studio
PRESS[STORE]1sec
Current patch number
Cursor
Giving the patch a name
_ U01¤Ttudio
NAME EDIT MODE
Cursor
A
to
Z
(space)
a
to
z
(space)
0
to
9 : ! " #
$ % & ' ( ) *
+ ,- . /
(space)
The characters that can
be set with each knob
→
• Moves the cursor to the left
(
←)
• Press simultaneously with
the [STORE/EXIT] button
to delete the character
selected with the cursor.
* Holding down the switch (and
button) repeats the same opera-
tion continuously.
• Moves the cursor to the
right ( →)
• Press simultaneously
with the [STORE/EXIT]
button to insert a space
where the cursor is.
* Holding down the switch (and
button) repeats the same op-
eration continuously.
■ Giving the patch a name (Name Edit Mode)
You can use up to 12 characters when making a name for a User Patch.
* Names of Preset Patches (P01-P99) can not be changed.
q
Press the [STORE/EXIT] button.
“PRESS[STORE]1sec” appears in the lower half of the display.
w
Press and hold the ON/OFF switch until “NAME EDIT MODE” appears on the
display.
The cursor appears below the first character of the patch name.
* The MAGICSTOMP will enter the Deep Edit Mode if the ON/OFF switch is released before “NAME EDIT
MODE” appears on the display, (
→ page 15).
e
Move the cursor to change characters.
Use the – and + switches to move the cursor to the character you want to change, then use the
three knobs to select the character.