Yamaha RX-N600 - Manual (Page 19)

15
En
CONNECTIONS
PREP
ARA
TION
■ Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
2
Loosen the knob.
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire.
■ Connecting the banana plug
(except Europe model)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables.
1
Tighten the knob.
2
Insert the banana plug connector into the
end of the corresponding terminal.
10 mm (0.4 in)
Red: positive (+)
Black: negative (–)
Banana plug
Red: positive (+)
Black: negative (–)