Yamaha RX-N600 - Manual (Page 95)

91
En
ADVANCED SETUP
AD
V
A
N
C
ED
OPERA
T
ION
■ Speaker impedance SP IMP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices:
8
Ω
MIN , 6
Ω
MIN
• Select “8
Ω
MIN” to set the speaker impedance to 8
Ω
.
• Select “6
Ω
MIN” to set the speaker impedance to 6
Ω
.
* The Canada model cannot use two separate speaker systems
(A and B) simultaneously when “SP IMP.” is set to “8
Ω
MIN”.
■ Factory presets PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 108).
Choices:
CANCEL , RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
• This setting completely resets all the parameters of this unit
including the “SET MENU” parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
■ Network reset N-RESET
Use this feature to reset the network settings of this unit
(see page 84) to the initial factory settings.
Choices:
CANCEL , RESET
• Select “CANCEL” not to reset any network settings of
this unit.
• Select “RESET” to reset the network settings of this
unit.
• The initial factory settings are activated next time you turn on
this unit.
• When the network settings are reset, “DHCP” in “NET/USB
MENU” is automatically set to “ON” (see page 84) and the
registered client ID of this unit on your YAMAHA MCX-2000
is cleared (see page 105).
■ Remote control AMP ID REMOTE AMP
Use this feature to set the AMP ID of this unit for remote
control recognition (see page 96).
Choices:
ID1 , ID2
• Select “ID1” when the remote control AMP ID library
code is set to “00001”.
• Select “ID2” when the remote control AMP ID library
code is set to “00002”.
You need to set the corresponding remote control AMP library
code for the remote control (see page 96).
SP IMP. Speaker Impedance level
8
Ω
MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 8
Ω
or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16
Ω
or
higher. *
Center
The impedance of each
speaker must be 8
Ω
or
higher.
Surround
Surround back
6
Ω
MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 4
Ω
or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8
Ω
or
higher.
Center
The impedance of each
speaker must be 6
Ω
or
higher.
Surround
Surround back
Notes
Notes
Note