Yamaha HTR-6090 - Manual (Page 95)

91
En
CUSTOMIZING THIS UNIT (MANUAL SETUP)
AD
V
ANCED
OPE
R
A
T
IO
N
Graphic equalizer GEQ
Use to match the tonal quality of the center, surround L/R
and surround back L/R, surround back, presence L/R
speakers and the subwoofer with that of the front L/R
speakers. You can adjust 7 frequency bands (63Hz,
160Hz, 400Hz, 1kHz, 2.5kHz, 6.3kHz, 16kHz).
Choices: –6.0 to +6.0 dB
Control step: 0.5 dB
y
Press k / n to select a frequency band and l / h to adjust the
selected frequency band.
The “GEQ” parameter can be adjusted only when “GEQ” is
selected in “SELECT”.
Test tone TEST TONE
Use this feature to make adjustments of “GEQ” while
listening to a test tone. To select “TEST TONE”, press n
repeatedly in the graphic equalizer screen.
Choices: OFF, ON
• Select “OFF” to stop test tones and output the currently
selected source component.
• Select “ON” to output test tones from the selected
speakers.
■ Low-frequency effect level
B)LFE LEVEL
Use this feature to adjust the output level of the LFE (low-
frequency effect) channel according to the capacity of
your subwoofer or headphones. The LFE channel carries
low-frequency special effects which are only added to
certain scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Control range: –20 to 0 dB
Control step: 1 dB
Speaker SPEAKER
Adjusts the speaker LFE level.
Headphone HEADPHONE
Adjusts the headphone LFE level.
Depending on the settings of “LFE/BASS OUT” (see page 86),
some signals may not be output at the SUBWOOFER OUTPUT
jack.
■ Dynamic range
C)DYNAMIC RANGE
Use this feature to select the amount of dynamic range
compression to be applied to your speakers or
headphones. This setting is effective only when this unit is
decoding Dolby Digital and DTS signals.
Choices: MIN, STD, MAX
• Select “MIN” (minimum) if you regularly listen at low
volume levels.
• Select “STD” (standard) for general use.
• Select “MAX” (maximum) to preserve the greatest
amount of dynamic range.
Speaker SP
Adjusts the speaker compression.
Headphone HP
Adjusts the headphone compression.
Note
. CHANNEL;;FRONT L
63Hz ;;;;;; 0.0dB
160Hz ;;;;;; 0.0dB
400Hz ;;;;;; 0.0dB
[ ]/[ ]:Up/Down
[ ]/[ ]:Adjust
A)EQUALIZER
-______+
p
p
p [
CHANNEL ;;FRONT L
16kHz ;;;;;; 0.0dB
. TEST TONE;;;;OFF
[ ]/[ ]:Up/Down
[ ]/[ ]:Adjust
A)EQUALIZER
-______+
p
p
p [
Note
. SPEAKER;;;;;;0dB
HEADPHONE ;;;;0dB
[ ]/[ ]:Up/Down
[ ]/[ ]:Adjust
B)LFE LEVEL
p
p
p [
. SP: MIN STD MAX
HP: MIN STD MAX
[ ]/[ ]:Up/Down
[ ]/[ ]:Select
C)DYNAMIC RANGE
p
p
p [
[
[
01EN_00_HTR-6090_U.book Page 91 Tuesday, June 27, 2006 6:40 PM