Zanussi ZWS 5883 User Manual
Page 19
Unscrew the three
bolts.
Slide out the relevant
plastic spacers.
Fill the smaller upper hole and the two large
ones with the corresponding plastic plug caps
supplied in the bag containing the instruction
booklet.
Positioning
Install the machine on a flat hard floor. Make sure
that air circulation around the machine is not im-
peded by carpets, rugs etc. Check that the ma-
chine does not touch the wall or other kitchen
units. Level the washing machine by raising or
lowering the feet. The feet may be tight to adjust
as they incorporate a self locking nut, but the
machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materials
under the machine to compensate for any un-
evenness in the floor.
If necessary, check the
setting with a spirit
level.
Water inlet
Warning! This appliance must be connected
to a cold water supply
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
Connect the hose to a
tap with a 3/4” thread.
Always use the hose
supplied with the ap-
pliance.
35°
45°
19