Zanussi ZWS 5883 - Manual (Page 7)

Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment
or in the appropriate compartment if
the selected programme/option it requires
(see more details in "Detergent dispenser draw-
er").
If required, pour fabric softener into the com-
partment marked (the amount used must
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
Select the required programme by turning
the programme selector dial (1)
Turn the programme selector dial to the required
programme. The washing machine will automat-
ically select the maximum spin value provided for
the programme you have chosen. You can change
this value by pressing the corresponding button.
The green pilot light of the button 6 starts to
flash.
The selector dial can be turned either clockwise
or counterclockwise. Turn to position « O » to
reset programme/Switching the machine off.
At the end of the programme the selector dial
must be turned to position O, to switch the ma-
chine off.
Caution! If you turn the programme
selector dial to another programme when
the machine is working, the red pilot light of
button 6 will blink 3 times to indicate a wrong
selection. The machine will not perform the new
selected programme.
Select the required temperature by turning
the temperature selector dial (2)
Turn clockwise this dial to select the more con-
venient to your laundry washing temperature.
Select the available options by pressing
buttons 3, 4 and 5
Depending on the programme, different func-
tions can be combined. These must be selected
after choosing the desired programme and be-
fore starting the programme.
When these buttons are pressed, the corre-
sponding pilot lights illuminate. When they are
pressed again, the pilot lights go out. If an incor-
rect option is selected, the integrated red pilot
light of the button 6 flashes for 3 times.
For the compatibility among the washing
programmes and the options see chapter
«Washing Programmes».
Start the programme by pressing button 6
To start the selected programme, press the but-
ton 6 , the corresponding green pilot light stops
blinking. The appliance starts operating and the
only pilot light corresponding to the running
phase stays on.
To interrupt a programme which is running, press
the button 6 : the corresponding green pilot light
starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
again .
If an incorrect option is selected, the red pilot
light of the button 6 blinks 3 times.
Altering an option or a running programme
It is possible to change some options before the
programme carries them out.
Before you make any change, you must PAUSE
the appliance by pressing the button 6 .
Changing a running programme is possible only
by resetting it. Turn the programme selector dial
to O and then to the new programme position.
Start the new programme by pressing the button
6 again. The washing water in the tub will be not
emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to « O » to cancel a pro-
gramme which is running. Now you can select a
new programme.
Opening the door
After the programme has started the door is
locked. If, for any reason, you need to open it, set
firstly the machine to PAUSE by pressing the but-
ton 6 . After a few minutes it will be possible to
open the door.
7