XFX 650I - Manual (Page 26)

Installing and Configuring the XFX nForce 650i Ultra Motherboard
12
Preparing the Motherboard
The motherboard shipped in the box does not contain a CPU or memory. You
need to purchase a CPU, a CPU fan assembly, and memory to complete this
installation.
Installing the CPU
Be very careful when handling the CPU. Make sure not to bend or break any
pins on the back. Hold the processor only by the edges and do not touch the
bottom of the processor.
Use the following procedure to install the CPU onto
the motherboard.
1. Unhook the socket lever by pushing down and away
from the socket.
2. Lift the load plate. There is a protective socket
cover on the load plate to protect the socket when
there is no CPU installed.
3. Remove the protective socket cover from the load plate.
4. Remove the processor from its protective cover,
making sure you hold it only by the edges.
It is a good idea to save the cover so that
whenever you remove the CPU, you have a safe
place to store it.
5. Align the notches in the processor with the
notches on the socket.
6. Lower the processor straight down into the socket
with out tilting or sliding it into the socket
Note: Make sure the CPU is fully seated and level in the
socket.
7. Close the load plate over the CPU and press down
while you close and engage the socket lever.
Align notches with
notches on the CPU