Yamaha HTR-5960 - Manual (Page 102)

98
ADVANCED SETUP
■ Speaker impedance
SP IMP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8
ΩMIN, 6ΩMIN
• Select “8
ΩMIN” to set the speaker impedance to 8 Ω .
• Select “6
ΩMIN” to set the speaker impedance to 6 Ω .
* The Canada model cannot use two separate speaker systems
(A and B) simultaneously when “SP IMP.” is set to “8
ΩMIN”.
■ Factory presets
PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 106).
Choices: CANCEL, RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
• This setting completely resets all the parameters of this unit
including the “SET MENU” parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
■ Remote control AMP ID
REMOTE AMP
Use this feature to set the AMP ID of this unit for remote
control recognition (see page 102).
Choices: ID1, ID2
• Select “ID1” when the remote control AMP ID library
code is set to “00001”.
• Select “ID2” when the remote control AMP ID library
code is set to “00002”.
You need to set the corresponding remote control AMP library
code for the remote control (see page 102).
■ Remote control TUNER ID
REMOTE TUN
Use this feature to set the TUNER ID of this unit for
remote control recognition (see page 102).
Choices: ID1, ID2
• Select “ID1” when the remote control TUNER ID
library code is set to “81916”.
• Select “ID2” when the remote control TUNER ID
library code is set to “81917”.
You need to set the corresponding remote control TUNER library
code for the remote control (see page 102).
■ Remote control XM ID
REMOTE XM
(U.S.A. model only)
Use this feature to set the XM ID of this unit for remote
control recognition (see page 103).
Choices: ID1, ID2
• Select “ID1” when the remote control XM ID library
code is set to “81918”.
• Select “ID2” when the remote control XM ID library
code is set to “81919”.
You need to set the corresponding remote control XM library
code for the remote control (see page 102).
SP IMP. Speaker Impedance level
8
ΩMIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 8
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16
Ω or
higher. *
Center
The impedance of each
speaker must be 8
Ω or
higher.
Surround
Surround back
6
ΩMIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 4
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8
Ω or
higher.
Center
The impedance of each
speaker must be 6
Ω or
higher.
Surround
Surround back
Notes
Note
Note
Note