Yamaha HTR-5960 - Manual (Page 34)

30
CONNECTIONS
If you are to use 4 or 6 ohm speakers, set “SP
IMP.” to “6
ΩMIN” as follows BEFORE using this
unit.
1
Make sure this unit is set to the standby
mode.
See page 31 for details about turning on this unit or
setting it to the standby mode.
2
Press and hold STRAIGHT (EFFECT) on the
front panel and then press STANDBY/ON to
turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the PROGRAM selector on the front
panel to select “SP IMP.”.
The following display appears in the front panel
display.
4
Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6
ΩMIN”.
The following display appears in the front panel
display.
5
Press STANDBY/ON on the front panel to
save the new setting and set this unit to the
standby mode.
The setting you made is reflected next time you turn on this
unit.
Setting the speaker impedance
CAUTION
PURE DIRECT
PRESET/TUNING
EDIT
FM/AM A/B/C/D/E PRESET/TUNING/CH
INPUT MODE TONE CONTROL MULTI CH INPUT STRAIGHT
EFFECT
MEMORY
MAN'L/AUTO FM LEVEL NEXT
TUNING MODE
AUTO/MAN'L
VOLUME
PROGRAM INPUT
STANDBY /ON
OPTIMIZER MIC
PHONES
SILENT CINEMA
SPEAKERS A B
OPTICAL R AUDIO L VIDEO S VIDEO
+
SEARCH MODE CATEGORY DISPLAY
VIDEO AUX
3 2,4
2,5
(U.S.A. model)
EFFECT
STRAIGHT
STANDBY
/ON
While holding
down
PROGRAM
S P I M P . - 8 M I N
Note
EFFECT
STRAIGHT
S P I M P . - 6 M I N
STANDBY
/ON