Xantrex Technology IP1012 AL - Manual (Page 31)

Replacing the Fuse
975-0337-01-01 3–5
To replace the fuse:
1. Lift the fuse cover off as shown in Figure 3-2.
2. Remove the blown fuse and install the new fuse.
Be sure to use a lock washer when replacing the nuts. Tighten to a
torque of 4 to 5.5 ft-lb (5.5 to 7.5 Nm).
.
3. Replace the fuse cover by placing it over the fuse and pressing down
until it snaps into place.
If the fuse blows a second time without being able to operate the unit,
do not change the fuse again. Call your authorized Xantrex dealer.
Figure 3-2 Removing the fuse cover
1
2
3
CAUTION: Do not overtighten fuse nuts!
IP1012_AL.book Page 5 Tuesday, May 1, 2007 12:18 PM