Xantrex Technology PROwatt 1000 - Manual (Page 19)

Front Panel (AC End)
2–3
Front Panel (AC End)
Figure 2-1 Front Panel: AC End
ON
OF F
➀
➆
➆
➃
➅
➄
➁
➂
Feature Description
➀ ➀ ➀ ➀ Remote Control Jack Located on the bottom of the inverter. It
allows you to connect the remote On/Off switch.
➁ ➁ ➁ ➁ On/Off Switch This switch turns the inverter’s control circuit on and
off. It is not a power disconnect switch. You must disconnect AC and
DC power before working on any circuits connected to the inverter.
➂ ➂ ➂ ➂ OVER LOAD Indicator This indicator lights when the inverter shuts
down because of an AC overload or a short circuit.
➃ ➃ ➃ ➃ OVER TEMP Indicator This indicator lights when the inverter shuts
down to protect itself from overheating. When the inverter cools, it
restarts automatically, and the indicator turns off.
➄ ➄ ➄ ➄ VOLTS and AMPS Indicators These display battery voltage and
current.
•
Current should be in the green area for continuous operation.
• When current is in the yellow area, the inverter will operate for
several minutes.
• When current or voltage are in the red, the inverter shuts down.
➅ ➅ ➅ ➅ AC Outlet Delivers 1000 watts of continuous AC power. This is a
Ground Fault Circuit Interrupter (GFCI) outlet.
➆ ➆ ➆ ➆ Mounting Flanges
PROWatt100.book Page 3 Friday, January 5, 2001 3:03 PM