Zanussi ZTK123 - Manual (Page 11)

11
Press this button to
start the dryer after
having selected the
programme and the
options. The relevant
light will stop flashing.
If the programme
selector dial is turned
to another position,
when the machine is
running, the buzzer
will sound and the
programme phase
indicator lights will
flash. The drum turns
alternately in both
directions during dry-
ing.
All drying pro-
grammes end with a
10 minute cooling
phase (light Cooling is
on). You may remove
the laundry after this
phase.
The display will show
the symbol Delicate
, and and
illuminate and the
buzzer sounds.
If the door of the
appliance or the small
door at the bottom is
opened while the pro-
gramme is running,
this button must be
pressed again after
closing the door in
order to restart the
programme from the
point at which it was
interrupted. This but-
ton must be
depressed also after a
power failure and
after having reinserted
the water reservoir, if
it has been emptied in
the middle of a pro-
gramme after lighting
up of light .
In both cases the light
of the Start/Pause
button flashes to
remind you that the
start button needs to
be pressed again.
Indicator lights
These lights indicate
the following func-
tions:
• Drying light
This light indicates
that the appliance
is in the drying
phase.
• End of pro-
gramme light
This light is on at
the end of the
cooling phase,
during the anti-
creasing phase
and at the end of
the programme.
• Water reservoir
full light
This light indicates
that the appliance
is in the drying
phase.
This light comes
on at the end of
the programme to
remind you that
the water reser-
voir must be emp-
tied out. If this
light illuminates
during a pro-
gramme this
means that the
water reservoir is
full. The buzzer
sounds, the pro-
gramme stops,
the light of the
Start/Pause
button flashes.
This light comes
on also when the
water reservoir is
not inserted cor-
rectly.
• Filter cleaning
This light illumi-
nates at the end
of the programme
to remind you that
the filters must be
cleaned.
• Condenser
cleaning
It comes on every
80 cycles to
remind you that
the condenser
must be cleaned.
Cancelling a
programme
Turn the selector dial
to “O” to cancel a pro-
gramme which is run-
ning. Now you can
select a new pro-
gramme.
At the end of the
programme
If the laundry is not
removed at the end of
the cycle, the dryer
performs an anti-
creasing phase (dura-
tion: 30 minutes maxi-
mum).
If you do not remove
the laundry, the dryer
will stop automatically
at the end of the anti-
creasing phase.
Lights End/Anticrease
, and remain lit
and the buzzer
sounds for 2 minutes.
Turn the programme
selector dial to “O” to
switch the machine
off. Remove the laun-
dry from the drum and
carefully check that
the drum is empty.
If you do not intend to
carry out another
wash, close the water
tap. Leave the door
open to prevent the
formation of mildew
and unpleasant
smells.
Turn the time selector
dial to “O”; all the
lights go out. The
appliance is switched
off.
Remove the laundry.
If you open and then
close the door before
turning the selector