Yamaha DME24N - Manual (Page 53)

P
anel Operation and Displa
ys
Utility Displays
DME64N/DME24N Owner’s Manual 53
GPI Setup (GPI) Page
Input calibration parameters for the [GPI] connector.
1 Reset
Resets GPI calibration.
To reset the calibration, use the [
E] [ ▲ ] [ ▼ ] [F]
keys to select ALL to reset all inputs, or select an individual
input from 1 to 16 to be reset, then press the [ENTER]
key.
2 MAX
Sets the maximum calibration value.
To set the MAX value, use the [
E] [ ▲ ] [ ▼ ] [F] keys
to select ALL to set all inputs, or select an individual input
from 1 to 16 to be set, then press the [ENTER] key to set
the MAX value to the current input voltage.
3 MIN
Sets the minimum calibration value.
To set the MIN value, use the [
E] [ ▲ ] [ ▼ ] [F] keys
to select ALL to set all inputs, or select an individual input
from 1 to 16 to be set, then press the [ENTER] key to set
the MIN value to the current input voltage.
4 Calibration Info
Shows the calibration settings as well as the current input
voltage.
2. Setting and parameter name display function
Displays the settings and parameter names on the DAW
controller’s LCD screen.
There are two display methods: over-all display and
detail display.
Overall Display:
The overall display shows the assigned parameter names
and settings, organized by DAW channels.
Detail Display:
In the detail display, you select the parameter you want
to display. Only information for that parameter
appears on the DAW controller’s LCD screen.
NOTE
The number of characters that can be displayed is limited by the
size of the DRAW’s LCD screen.
3. User Label Function
Lets you attach names to assigned parameters.
For details about settings, see the “DME Designer
Owner’s Manual.”
NOTE
This page will not appear on the ICP1 display.
1
2
3
4