Xerox 155 - Manual (Page 57)

Controller requirements and specifications
Installation Planning Guide 5-5
Controller placement
WARNING
The controller must be positioned within the line-of-sight of
the printer for safety purposes while servicing the
equipment.
The controller components are placed in the accompanying
controller stand. You should consider the following factors when
deciding where to place the controller and stand:
• There should be at least 36 inches / 15.2 cm of clearance on
all sides of the controller stand.
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system
in an area where you can restrict access to it.
Guidelines for controller placement
To ensure consistent performance and avoid any damage to
equipment, follow these rules for placing the components of the
controller.
Do:
• Use the controller stand that comes with your printing system
equipment.
• Allow at least 6 inches / 152 mm of unobstructed space at the
front and rear of the processor, so the fan and vents are not
blocked.
The following illustration shows fan and vent locations on the
front and back of the processor.