ZyXEL Communications PRESTIGE 128 - Manual (Page 117)

104 Filter Configuration
Figure 10-6 Menu 21.1.3 - IPX Filter Rule
1. IPX Packet Type - Enter the IPX packet type value of the
packet you wish to filter. This value should be two hex-bytes.
2. Destination/Source Network # - Enter the four hex-byte
destination/source network numbers of the packet that you
wish to filter.
3. Destination/Source Node # - Enter in the six hex-byte value
for the destination/source node number of the packet you wish
to filter.
4. Destination/Source Socket # - Enter the destination/source
socket number of the packets that you wish to filter. This
should be a 4-byte hex value.
5. Destination/Source Socket # Comp - You can select what
comparison quantifier you wish to use to compare to the value
given in Destination Socket # and Source Socket #.
6. Operation - This field is only active if one of the Socket #
fields is 0452 or 0453 indicating SAP and RIP packets. There
are seven options for this field which determines the operation
for the IPX packet.
•
None.