Zanussi jetstream ZJD12191 - Manual (Page 12)

12
5. Select the SPIN speed or RINSE
HOLD option
Depress the spin speed button to choose the required
speed or RINSE HOLD option
: the corresponding
light comes on.
6. Select the required options
The light corresponding to the depressed button
illuminates.
7. Select the Delay Start option
To delay starting of a programme, press the DELAY
START button. The corresponding light illuminates. The
figures corresponding to the selected delay will be
displayed for about 3 seconds, after which the duration
of the selected programme will appear on the display.
When the START PAUSE button is pressed, the
selected delay will again appear on the display and the
machine starts its countdown.
DELAY
START
QUICK
WASH
SUPER
RINSE PREWASH DAILY
SPIN
SPEED
1200
900
700
500
During this period it is possible to load other laundry:
press the START PAUSE button. Open the door. Load
the laundry. Close the door and press the START
PAUSE button again.
8. Start the programme
To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing and the
(Door) pilot light illuminates.
The pilot light corresponding to the wash phase which is
running is on.
The machine starts operating.
If the D
ELAY
S
TART
option has been selected the
programme will start at the end of the countdown.
9. At the end of the programme
The machine stops automatically. The display shows a
blinking zero.
If the RINSE HOLD
option has been selected, the
door will be locked, the light of the START PAUSE
button and the
(D
OOR
) pilot lights go out , the
light remains lit to indicate that the water must be
drained before opening the door. The display shows a
flashing zero.
To empty out the water you can after turning the
programme selector dial to X position:
●
select programme (D RAIN ), the water is emptied
out without spinning
●
select programme (S
PIN
). Select the spin speed by
means of the relevant button and then depress the
START/PAUSE button. The water is emptied out and
the laundry is spun at the selected spin speed.
At the end of the cycle, the light of the START PAUSE
button and the
(D
OOR
) pilot light go out, and the
(E ND ) light illuminates. The door can be opened.
Turn the programme selector dial to Reset X.
START
PAUSE