Zanussi jetstream ZJD12191 - Manual (Page 9)

9
13 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, the
(D
OOR
) pilot
light and only the running phase light illuminate and
stay on.
When the programme has finished, the
(
END
) pilot
light comes on and the the
(D
OOR
) pilot light goes off.
The (D
OOR
) pilot light indicates if during the
washing cycle the door can be opened:
• Light on: the door can be opened
(when the washer-dryer is set to PAUSE, the
(D
OOR
) pilot light will go off).
• Light off: the door cannot be opened
(when the washer-dryer is set to PAUSE, the
(D
OOR
) pilot light will start to flash)
The (
END
) pilot light flashes in the event of
operating problems and the corresponding alarm code
appears on the display.
EE1100 = the machine does not fill
EE2200 = the machine does not empty
EE4400 = the door has not been closed
To eliminate the problem, see paragraph “Something not
working”.
14 Programme selector dial
The selector is divided into 5 sections:
• C
OTTON
,
• S YNTHETICS
• D ELICATES
• W OOL (hand washing)
• Special programmes
Reset programme X
WASH
DRYING
DOOR
PREWASH
SPIN
END
RINSES
DRAIN
The selector dial can be turned either clockwise or
anticlockwise.
Position E corresponds to the ENERGY SAVING
programme and position
to “cold wash”.
Position corresponds to the drying programme.
At the end of the programme the selector dial must
be turned to position X (reset).
Functions
End of programme
When the (
END
) pilot light on the programme
progress display illuminates, if the (D
OOR
) pilot
light has gone out, the the door can be opened (if the
(
RINSE HOLD
) option has not been selected) .
Turn the programme selector dial to X.
Switch the machine off by depressing the ON/OFF
button before removing the laundry.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washer dryer by pressing the START PAUSE button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to "X" and
then to the new programme position. The washing water
in the tub will not emptied out .
Start the new programme by depressing the START
PAUSE button.
Interrupting a programme
Depress the START PAUSE button to interrupt a
programme which is running: the corresponding light
starts to flash.
Depress the same button to restart the programme.
95º
E
60º
40º
30º
60º
40º
30º 40º
30º
X
40º
COTTON
DELICATES SYNTHETICS
WOOL
60º
SPECIAL
40ºE
60ºE
30º