Zanussi ZKG5030 - Manual (Page 32)

32
478mm (B)
250mm
20mm
100mm
(A)
Stability
bracket
3.
Draw a line 100mm from the front edge of
the feet and remove appliance from its
position. Mark off dimension 'B' back from
this line on the centre line of the bracket to
locate the front edge of the lower bracket.
Fix lower bracket (with two fixing holes) to
the floor then measure the height from floor
level to engagement edge on back of
appliance, dimension 'C'.
(C)
Stability
bracket
•
Assemble upper bracket to lower bracket so
that the underside of bracket is dimension 'C'
+ 3mm above floor level.
•
Reposition appliance and check that top
bracket engages into appliance back as
shown.
The battery
1. The battery is located on the left hand side of
the front plinth.
2. To gain assess to the battery, open the main
oven door and lift up the battery holder lid.
3. Fit the new battery ensuring (+) terminal is
next to the (+) sign on the battery.
4.
Close the lid of the battery holder.
Pressure testing
1. The oven injector is used as a pressure test
point. Remove the oven furniture.
Remove oven burner box retaining clips (one
spring clip from each side) and remove box
front cover. Replace one clip back into the
right hand side of the burner box.
Remove oven burner by removing the spring
clip from the right hand side of the oven
burner and slide burner off injector, whilst
easing it forward and taking care not to strain
the F.S.D. phial.
2. Connect the pressure gauge to the oven
injector.
3. Check the supply pressure by turning the
thermostat on and one hotplate tap full on