Connecting the unit, Connecting a/v components, Connections english – Yamaha DPX1000 User Manual
Page 14: Make sure to match the y/p, Or y/c
E-
9
CONNECTIONS
English
DVI
INPUT B
RGB/YP
B
P
R
/YC
B
C
R
D4 VIDEO
G/Y
B/P
B
/C
B
R/P
R
/C
R
INPUT A
HD/SYNC
VD
OUT
IN
REMOTE
RS-232C
S-VIDEO
VIDEO
TRIGGER OUT
G/Y
R/P
R
/C
R
B/P
B
/C
B
◆ Note ◆
•
Make sure to match the Y/P
B
/P
R
or Y/C
B
/C
R
of the A/V component and this unit when connecting a component to INPUT A compo-
nent jacks. Also, refer to the operation instructions for the A/V component. HD/SYNC and VD need to be connected for RGB video
signals in some cases.
Connecting the unit
•
Make sure that the power of this unit and all other components is turned off before making any connections.
•
Some components have different connection methods and connector names.
Refer to the operating instructions for each component that you wish to connect.
•
Plug the unit in correctly to prevent it from creating noise or other problems.
■ Connecting A/V components
As shown in the illustration below, there are 5 types of connections provided on this unit for connection to A/V components.
Follow the instructions on the figure below to connect A/V video outputs from other components to this unit using the correct cables and
adapters.
D connector cable
D-sub monitor
cable
BNC cable for component
connection
Pin/BNC
adapters
Pin cable
Video pin cable
S video cable
D1—4 output
connectors
Pin jacks
D-sub
Component/RGB video output connectors
Image output from A/ V components
BNC jacks
S video output
jack
Video output
jack
Input
VIDEO
S-VIDEO
INPUT A
INPUT B
D4 VIDEO
DVI
Signal type
Composite video
S video
Component video/RGB video
Component video/RGB video
Component video
Component video/RGB video (digital)
Connector type
Pin jack
Mini DIN connector
BNC connector x 3—5
D-sub 15 pin
D connector
DVI connector
DVI cable (digital)
DVI output
connector