Yamaha CP 33 - Manual (Page 40)

Detailed Settings
CP33 Owner’s Manual 40
Ref
erence
Program Change ON/OFF
Normally the CP33 will respond to MIDI program change
numbers received from an external keyboard or other
MIDI device, causing the correspondingly numbered
Voice to be selected on the corresponding channel (the
keyboard Voice does not change). The CP33 will normally
also send a MIDI program change number whenever one
of its Voices is selected, causing the correspondingly
numbered Voice or program to be selected on the external
MIDI device if the device is set up to receive and respond
to MIDI program change numbers.
This function makes it possible to cancel program change
number reception and transmission so that, for example,
voices can be selected on the CP33 without affecting the
external MIDI device.
n For information on program change numbers for each of
the CP33’s Voices, refer to MIDI Data Format page 51.
• Setting range: ON/OFF
• Default setting: ON
Control Change ON/OFF
Normally the CP33 will respond to MIDI control change
data received from an external MIDI device or keyboard,
causing the Voice on the corresponding channel to be
affected by pedal and other "control" settings received
from the controlling device (the keyboard Voice is not
affected).
The CP33 also transmits MIDI control change
information when the pedal or other appropriate controls
are operated.
This function makes it possible to cancel control change
data reception and transmission so that, for example, the
CP33's pedal and other controls can be operated without
affecting an external MIDI device.
n For information on control changes that can be used with
the CP33, refer to MIDI Data Format on page 51.
• Setting range: ON/OFF
• Default setting: ON
Initial Setup Send
This function lets you send the data of the panel settings to
a computer. By transmitting the panel settings and
recording them on the MIDI sequence recorder prior to
the actual performance data, the instrument will be
automatically restored to the same settings when the
performance is played back. You can also use this function
to change the settings of a connected tone generator to the
same settings as the instrument.
1. Set up the panel controls as desired.
2. Connect the CP33 to a sequencer via MIDI, and set up
the sequencer so it can receive the setup data.
3. Call up the Function menu and select .
4. Press the [YES/+] button to transmit the panel/status
data.
will appear on the display when the data has been
successfully transmitted.
The following data can be sent.
• Voice selection
• [REVERB] type
• [REVERB] depth
• [EFFECT] type
• [EFFECT] depth
• Split point
• Tuning (F1)
• Dual detune (F3.1)