Yamaha AR-80 - Manual (Page 95)

89
4.
Use the SONG SELECT buttons (or the
corresponding controls in the display) to select the
song number for recording.
5.
Press the REC button (or select the corresponding control in the display).
The REC button lamp lights and the PLAY button flashes to
indicate that record is set to standby.
6.
Press the PLAY button.
The PLAY lamp lights up and small dashes flash across the LED display from left to right,
indicating that the M.D.R. is reading the Registrations and other settings.
STOP PLAY SONG SELECT REC
MUSIC DISK RECORDER
DISK IN USE ---- 00:00
DATA CONTROL
STOP PLAY SONG SELECT REC
MUSIC DISK RECORDER
DISK IN USE 01
STOP PLAY SONG SELECT REC
MUSIC DISK RECORDER
DISK IN USE 01
If the selected song number
already contains recorded data,
two dashes (“- -”) appear at the
left part of the M.D.R. LED
display and flash along with the
song number, warning you that
the selected song number
already contains recorded data.
If you want to execute recording
operation over the song
number, press the REC button
again. To avoid recording over
the data, select another song
number for recording or press
the STOP button to cancel
recording.
When a disk is first inserted,
song number 1 is automatically
selected. Song numbers 1
through 40 are available and up
to 40 songs can be stored on a
disk. However, the amount of
available song numbers may be
less depending on the amount
of the song data you have
recorded.