4XEM IPCAMWL40 - Manual (Page 38)

- 37 -
Network settings
Any changes made to this page will restart the system in order to validate the changes.
Make sure every field is entered correctly before clicking on
.
"Reset IP address at next boot", the default status is checked to get IP address
automatically at the server start. Therefore, once the network settings, especially the
IP address, have been entered correctly, uncheck this option
General
“IP address” This is necessary for network identification.
“Subnet mask” This is used to determine if the destination is in the same subnet. The
default value is “255.255.255.0”.
“Default router” This is the gateway used to forward frames to destinations in a
different subnet. Invalid router setting will fail the transmission to destinations in
different subnet.
“Primary DNS” The primary domain name server that translates hostnames into IP
addresses.
“Secondary DNS” Secondary domain name server that backups the Primary DNS.
HTTP
“Http port” This can be other than the default port 80. Once the port is changed, the
users must be notified the change for the connection to be successful. For instance,
when the Administrator changes the HTTP port of the Network Camera whose IP
address is 192.168.0.100 from 80 to 8080, the users must type in the web browser
“http://192.168.0.100:8080” instead of “http://192.168.0.100”.
Streaming
“Control channel port” This can be something other than the default port 5001 in