Epson Perfection 2580 - Manual (Page 5)

Epson Perfection 2580 Photo
6/04 Epson Perfection 2580 Photo - 5
3. Place a 35 mm slide into the holder with its shiny base side
facing down. Your image should appear backwards on the
side that faces up.
Place the top of the image toward the left side of the
scanner.
4. Close the scanner cover.
5. To scan your slide, press the 4 Scan and Save button or
open EPSON Smart Panel and select Scan and Save . This
scans your slide using ideal settings in Full Auto Mode and
opens it in ArcSoft PhotoImpression for viewing, editing,
and printing. See your on-screen Reference Guide and Smart
Panel help for instructions on selecting scan modes and
complete scanning details.
6. When you’re finished scanning, you can store the slide
holder in the scanner cover. Slide the holder into the cover,
then replace the document mat.
Start Light
The scanner’s ] Start light indicates the scanner status.
Transporting the Scanner
Before transporting the scanner for a long distance or storing it
for an extended period of time, you need to lock the scanner’s
carriage to prevent damage.
1. Plug in the scanner, connect it to your computer, and wait
until the carriage moves to the home position (position
nearest the buttons). While the
]
Start light is green,
unplug the scanner.
2. If the cover cable is attached, disconnect it.
] Start light Scanner status
Flashing green Warming up or scanning.
Green Ready to scan.
Flashing red Make sure the transportation lock is unlocked.
Try restarting your computer and unplugging the
scanner. Wait 10 seconds, then plug the scanner
back in.
Film may be jammed in the auto film loader.
Disconnect the scanner from the computer, wait
10 seconds, and connect it to the computer again
to see if the film ejects on its own. If film is still
jammed, see your on-screen Reference Guide.
If the red light is still flashing, contact your dealer
or Epson.
Off Make sure your scanner is connected to your
computer and plugged into a power source.