8e6 Technologies Threat Analysis Reporter TAR 1.0 - Manual (Page 6)

 8
e
6 T
hreaT
a
nalysis
r
eporTer
Q
uick
s
TarT
G
uide
About this Document
This document is divided into the following sections:
Introduction - This section is comprised of an overview of the Threat Analysis Re-
porter product and how to use this document
Service Information - This section provides 8e6 Technologies contact information
Preliminary Setup Procedures - This section includes instructions on how to physi-
cally set up the Threat Analysis Reporter unit in your network environment
Install the Server - This section explains how to configure the Threat Analysis Re-
porter
Conclusion - This section indicates that the quick start steps have been completed
Specifications - This section features hardware specifications and descriptions of
front panel LED indicators
Appendix: Optional Ethernet Tap Installation - This appendix explains how to
install the optional Ethernet Tap device on your network for bandwidth monitoring if
you have a TAR “S” or TAR “H” server
Conventions Used in this Document
The following icons are used throughout this document to call attention to important
information pertaining to handling, operation, and maintenance of the server; safety and
preservation of the equipment, and personal safety:
NOTE: The “note” icon is followed by additional information to be consid-
ered.
WARNING: The “warning” icon is followed by information alerting you to a
potential situation that may cause damage to property or equipment.
•
•
•
•
•
•
•