Delta 1.07 VFD-D D - Manual (Page 65)

Chapter 4 Parameter Settings|DD Series
4-41
Multi-function Output (MO3)
Factory setting: 0
Settings Control mode VF VFPG SVC FOCPG FOCPM
0: No function ○ ○ ○ ○ ○
1: AC drive in operation ○ ○ ○ ○ ○
2: Zero speed frequency signal (including STOP)
○ ○ ○ ○ ○
3: AC drive ready
○ ○ ○ ○ ○
4: Low voltage warning(Lv) ○ ○ ○ ○ ○
5: Fault indication ○ ○ ○ ○ ○
6: Overhead warning (Pr.06.09)
○ ○ ○ ○ ○
7: Detection of braking resistor action level ○ ○ ○ ○ ○
8: Warning indication ○ ○ ○ ○ ○
9: Over voltage warning ○ ○ ○ ○ ○
10: OD command
○ ○ ○ ○ ○
11: CD command ○ ○ ○ ○ ○
12: Demo Indication ○ ○ ○ ○ ○
13: Demo complete ○ ○ ○ ○ ○
14: Emergency stop indication ○ ○ ○ ○ ○
15: Force stop indication
○ ○ ○ ○ ○
16: Door open complete (limit) signal output ○ ○ ○ ○ ○
17: Door close complete (limit) signal output ○ ○ ○ ○ ○
18: Door Close Error
○ ○ ○ ○ ○
19: Position Complete Signal ○ ○ ○ ○ ○
20: Position Detection 1(for door close only) ○ ○ ○ ○ ○
21: Position Detection 2(for door close only) ○ ○ ○ ○ ○
22: Position Detection 3(for door close only))
○ ○ ○ ○ ○
23: Position Detection 1(for door open only) ○ ○ ○ ○ ○
24: Position Detection 2(for door open only) ○ ○ ○ ○ ○
25: Position Detection 3(for door open only) ○ ○ ○ ○ ○
26: PG feedback error ○ ○ ○ ○ ○
27: output signal when unable to open the door
28: over torque (OT1)
These parameters can be used for external terminal output
Summary of Function Settings
Settings Functions Descriptions
0 No function MO has no function.
01 AC drive in operation The drive is ON when it receives voltage or operation command.
2
Zero speed frequency signal
(including STOP) Zero speed output signals (including STOP).
3 AC drive ready
Active when the drive is ON and no abnormality detected or
abnormality is cleared.
4 Low voltage warning(Lv) Active when the detected input voltage is too low.
5 Fault indication Active when fault occurs.
6
Overhead warning (Pr.06.09) Active when IGBT or heat sink overheats to prevent OH turn off
the drive. When temperature higher than 85 = ON, lower than ℃
<80 = OFF ℃ .
7
Detection of braking resistor
action level Active when drive begins software braking, this signal can be
used as brake module VFDB action signal or indicator.
8 Warning indication Active when warning is detected.
9 Over voltage warning Active when over-voltage is detected.