2Wire 2000 Series - Manual (Page 8)

Connect the First Computer to the Gateway
4
Ethernet Connection
Figure 1. Gateway Connected Via Ethernet
1. Connect the provided power adapter from the gateway's POWER port to an electrical outlet. The POWER
light on the front of the gateway should be green.
2. Connect the provided gray phone cable from the gateway's PHONE LINE port to the DSL filter jack
labeled DSL/HPNA .
3. Connect the yellow Ethernet cable provided with the gateway from any available ETHERNET port on the
gateway to your computer’s Ethernet port.
Check Your Connections
With your computer completely started, verify the POWER and ETHERNET indicator lights on the front of the
2Wire gateway are green. If they are not, see “Understanding the Indicator Lights” on page 19. The
INTERNET indicator light will not turn green until the gateway software has been installed and an Internet
connection has been established.