8e6 Technologies Enterprise Reporter SL-002-002 - Manual (Page 18)

 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
Install the SL or HL Server Bezel
After rack mounting an SL or HL server, the bezel should be installed on the front end of
the chassis.
NOTE: This portion of the installation process requires you to unpack the bezel.
The bezel has been packaged separately from the unit to prevent damage during
shipping.
A. Hold the bezel upright and facing towards you (Fig. 1).
Fig. 1 - Front of bezel
B. Note that each end of the bezel contains two raised bumps (Fig. 2).
Fig. 2 - Bumps on right end of bezel Fig. 3 - Grooves in right U-shaped handle
C. Align these bumps along the two parallel grooves inside each U-shaped aluminum
chassis handle affixed to the front end of the chassis rail (Fig. 3).
D. Push the bezel towards the front of the chassis, inserting the USB B-type plug on the
back of the bezel (Fig. 4) into the USB port on the chassis.
Fig. 4 - Section of back of bezel with USB B-type plug