8e6 Technologies Enterprise Reporter SL-002-002 - Manual (Page 34)

0 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
D. Power on the ER by lowering the bezel and pressing the large button at the right of
the front panel (see diagrams below):
Diagram of SL chassis front panel, power button at far right
Diagram of HL chassis front panel, power button at far right
WARNING: The ER is an information database. If you experience a power inter-
ruption or power off the ER in any manner other than from the Web-based interface
utility described in the sub-step Physically Connect the ER to the Network, you may
lose data and/or damage the file system.
The Boot Up Process
The boot-up process may take 5 - 10 minutes. When the drive light remains off for 30
seconds, the system is booted up. (See the LED Indicators and Buttons section for a
description of front panel LED indicators and buttons.)
If you wish to verify that the unit has been booted up, you can perform the following test
on your workstation:
1. Go to your taskbar and click Start > Run.
2. In the dialog box, type in cmd (type in command if using Windows ME).
3. Click OK.
4. In the cmd.exe window, type in ping 1.2.3.4
5. Press Enter on your keyboard.
If you receive a reply, the unit is up.