Epson 7900p - Manual (Page 15)

Epson PowerLite 7900p Projector
9/04 Epson PowerLite 7900p Projector - 15
Setting Up the Network
Connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a
commercially available 100baseTX or 10baseT network
cable. Plug the cable into the projector’s Ethernet port.
2. Turn on the projector.
3. Press the Menu button on the remote control and select
Network from the Advanced2 menu.
4. If your network assigns addresses automatically, turn on
DHCP .
5. If your network does not assign addresses automatically,
turn off DHCP and enter the projector’s IP Address ,
Subnet Mask , and Gateway Address , as needed.
❏ To enter numbers using the remote control, press the
Num button until it lights, then use the numeric
keypad.
❏ To change the network addresses from the projector’s
control panel, press the right and left arrow buttons to
select the part of the address you want to enter, then
use the up and down arrow buttons to increase or
decrease the numeric value.
Note: If you’re a network administrator, you can use the
SNMP option to enter a trap IP address. This lets you receive
trap alerts for the projectors you’re monitoring. If you have
HP OpenView, a plug-in is available to allow you to manage
your projectors in HP OpenView. Check with your dealer or
Epson.
When you finish changing an address in the network menu,
press the
Enter button (on the remote control) or the
Auto/Enter button (on the projector). This stores the
value.
6. When you’re done making all necessary changes, press ESC
to exit the menu system.
Opening and Closing EMP Monitor
To start EMP Monitor, click Start > Programs or All
Programs > Epson Projector > EMP Monitor .
If you’ve added the program to the Startup programs folder, it
may already be open. If so, click the icon in the system tray on
the lower-right corner of your screen to display the EMP
Monitor window:
To close EMP Monitor, right-click the program icon shown
above, then select
Exit .
To network port
Ethernet port
Brightness Control Brightness Control High High Low Low : Video Video
Audio Audio
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
About About
Reset All Reset All
Projector ID Projector ID
Network Network
Reset Reset Execute Execute
: 1 : 1
[Menu]: Exit [Menu]: Exit [ ]: Enter [ ]: Enter [ ]: Select [ ]: Select
Effect Effect
Advanced2 Advanced2
COM Port COM Port
BNC Sync Termination BNC Sync Termination
:
ON ON OFF OFF :
Set Set
Set Set
RS-232C RS-232C USB USB
Auto setup Auto setup ON ON OFF OFF :
Select
Network
Num button
Zero
Increase or
decrease
the value
Select the part of the
address to change
Click here to start EMP Monitor