Epson 7900p - Manual (Page 22)

Epson PowerLite 7900p Projector
22 - Epson PowerLite 7900p Projector 9/04
6. To remove the lamp cover, insert the screwdriver supplied
with the spare lamp (or another flat-tipped screwdriver),
into the space beside the air vent to gently lift the lamp
cover off.
7. Loosen the two screws holding the lamp in place. (You
don’t need to remove them.)
8. Grasp the wire handle as shown and pull the lamp straight
out.
9. Gently insert the new lamp.
10. Once the lamp is fully inserted, tighten its screws and
replace the cover. (The projector won’t come on if the lamp
cover is loose.)
11. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer
using the projector’s About menu.
1. Press the Menu button on the remote control or the
projector’s control panel to display the main menu.
2. Use the pointer button on the remote control (or the
arrow buttons on the projector) to highlight About , then
press Enter .
You see this screen:
Note: The lamp usage timer shows 0H until you’ve used the
lamp for at least 10 hours.
3. Select Reset Lamp
Timer . You see this
prompt:
4. Select Yes .
5. When you’re finished, press ESC or Menu to exit.
Transporting the Projector
The projector contains many glass and precision parts. Follow
these guidelines to prevent injury or damage when
transporting it:
❏ When hand-carrying the projector, you should use the
handle to carry it only a short distance (for example, to set
it on a table).
❏ When shipping the projector for repairs, use the original
packaging material if possible. If you do not have the
original packaging, use equivalent materials, placing plenty
of cushioning around the projector.
❏ When transporting the projector a long distance, first place
it in a hard-shell shipping case, and then pack it in a firm
box, placing cushioning around the case. (An optional ATA
shipping case is available from Epson; see the following
table.)
1
Insert the screwdriver here
Video Video
Audio Audio
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
About About
Reset All Reset All
Frequency Frequency
Video Source Video Source
V ---.---Hz V ---.---Hz
Reset Lamp Timer Reset Lamp Timer
H ---.---kHz H ---.---kHz
Lamp Lamp 1400H 1400H
SYNC Mode SYNC Mode
SYNC Polarity SYNC Polarity
------ ------
V ------ V ------
H ------ H ------
Resolution Resolution
Refresh Rate Refresh Rate ---.-- Hz ---.-- Hz
----x ---- ----x ----
Computer1 Computer1
Input Signal Input Signal
:
:
:
:
:
:
:
: Analog-RGB Analog-RGB
Execute Execute
[ ]: Select [ ]: Select [ ]: Enter [ ]: Enter [Menu]: Exit [Menu]: Exit
Effect Effect
Advanced2 Advanced2
Lamp usage